Plastic parts deformation solution?

It's neccessay to make Mold flow to check the deforamtion. 

Reason:

The deformation of injection Molded parts can occur in several environments, one of which is during deMolding/immediately after deMolding

The second type only appears after a period of time after deMolding. The first situation is due to poor curing conditions/poor Mold design

Another type of deformation in injection Molded parts is caused by poor injection pressure conditions during the injection Molding process.

Improvement methods:

a) Plastic

Replace with stronger/fiber-reinforced plastic materials.

Replace with high deMolding efficiency additive grade materials

b) Mold

Check the smoothness/calibration rate of the cooling pipeline

Add cooling pipes

Increase the smoothness of the lower mold

Increase the inclination of the mold when exiting

Check/add mold venting.

Optimize the top out system

Increase the strength of the mold

Add molded ribs

Injection Molding machine conditions

Reduce the holding pressure

Reduce the holding time

Optimize the pressure transfer point

Reduce mold temperature

Optimize the ejection speed

Increase cooling time